back to Multiply Home View Movie
choose Multiply Underlayment
About Multiply® Home | Product | Installation | Warranty | FAQ | Contact

Installation Guide

Preparation Underlayment and Subfloor

Tools for the job
Material for the job
People for the job
Crawl spaces
Over existing vinyl floors

Installation Vinyl Sheet & Tile

Setting the first panel
Fastening all other panels
Final check
Installing the new vinyl floor covering
Avoid Going Wrong

Installation Ceramic Tile

Setting the first panel
Fastening all other panels
Installation - mortar
Installation - setting tile

View installation video

Installation Guide and Warranty
English (PDF)
Guide de pose et garantie

French (PDF)
Guía de instalación y garantía
Spanish (PDF)

Get Adobe Reader







Installation Vinyl Sheet & Tile


DO NOT install panels without acclimating first.

DO NOT fasten a panel down by the four corners first then go back to fill “the field” later.

DO NOT lay more that one panel at a time.

DO NOT place panel seams directly over subfloor seams.

DO NOT allow the corner of panels to meet in an intersection.

DO NOT leave gaps between panels. (Except ceramic tile and general purpose panels - leave a 1/8” gap).

DO NOT patch normal edge joints where there are no gaps.

DO NOT fail to sand all seams.

DO NOT work without wearing safety equipment - a dust mask for sanding and protective safety goggles when stapling.

Home | Product | Installation | Warranty | FAQ | Contact | Entrance
Copyright © 2001-2005 All rights reserved - Web design by Voras